You are here: Electronic Dog Training Collars > Pet Containment Systems >> Innotek Smart Dog Containment Systems >> Installation Guide and FAQ >> Basic Installation Front and Back Yard
 

Basic Installation Front and Back Yard This type of boundary set up is probably the easiest and most common installation. The entire lot including your home is enclosed in the loop. Twisted Wire is used for the run from the transmitter (in Garage) to the perimeter. Using 2 pieces of single strand boundary wire twisted together produces no boundary. We recommend you twist this wire using an electric drill or something similar. You want approximately 1 twist per inch. Remember that as it twists it will draw up, so allow plenty of extra length. You may cross a paved or concrete drive way by several methods: Run the wire through an existing seam or crack in the drive. Run the wire through an existing drainage pipe under the drive. Caution: Since the wire will be deeper below ground your field width may be narrowed. We recommend you test the system in this area to be certain the collar is receiving a signal. You may cut a concrete or paved drive using a circular saw with a masonry blade. After inserting the wire in the cut fill the cut with heavy caulk or asphalt patch. Click picture for a larger view. Petsafe In-Ground Containment Systems Petsafe Standard In-Ground Dog Fence [ RF-3004W ] PetSafe Premium In-Ground Fence (PRF-3004W) PetSafe Premium Deluxe In-Ground Radio Fence (PRF-304W) PetSafe In-Ground Stubborn Fence (PIG00-10777) PetSafe Comfort-Fit Deluxe Little Dog In-Ground Fence System (PIG00-10773) Petsafe In-Ground Deluxe Radio Cat Fence PIG00-11007 PetSafe Wire & Flags Kit (PRFA-500) Innotek Lightning Protection Module LP-4100 Installation Guide and FAQ BROWSE NEXT: Basic Installation Back Yard Only.

Try out our on-line shopping cart! Click the "Add to My Shopping Cart" button. You can always remove it later. Ordering over the internet is safe and easy. Click here to see your order or to check out. -- Go to top of page.